Radiator cap
03-28-2011, 09:00 PM
#1
TECH Resident
Thread Starter
iTrader: (4)
Join Date: Feb 2009
Location: Ohio
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
Radiator cap I'm finishing up my 5.3L swap into my 88 Z31. I would like to run an inline radiator cap like this guy did with his TPI:
http://www.az-zbum.com/images/engine.z31.v8.1.jpg
As long as I bleed it fully, will there be any issues with the LSx engines and a cap that is not the highest point in the cooling system? Also, where should I put the steam lines from the heads if I run a setup like in the picture?
Thanks in advance.
http://www.az-zbum.com/images/engine.z31.v8.1.jpg
As long as I bleed it fully, will there be any issues with the LSx engines and a cap that is not the highest point in the cooling system? Also, where should I put the steam lines from the heads if I run a setup like in the picture?
Thanks in advance.
