Lm7 dbw to dbc
03-26-2017, 07:58 PM
#1
Registered User
Thread Starter
Join Date: Mar 2017
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Lm7 dbw to dbc I recently bought a lm7 out of a 2005 Tahoe which came stock with a drive by wire intake/tb on it. What all do I need to after the new intake and tb is swapped on?
03-27-2017, 09:12 AM
#5
Restricted User
The intakes themselves are pretty much the same. You will just need a throttle cable, throttle cable bracket and a throttle body with sensors. Then you'll have to grab the wiring for the TPS and IAC from sensor to PCM and pin them into your harness.
Last, you'll need a PCM that can control DBC.
Last, you'll need a PCM that can control DBC.
03-28-2017, 03:16 PM
#6
Registered User
Thread Starter
Join Date: Mar 2017
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
The intakes themselves are pretty much the same. You will just need a throttle cable, throttle cable bracket and a throttle body with sensors. Then you'll have to grab the wiring for the TPS and IAC from sensor to PCM and pin them into your harness.
Last, you'll need a PCM that can control DBC.
Last, you'll need a PCM that can control DBC.
