zapp109

iTrader: (13)

I bought my car with a intank 255 pump and it already has braided lines from the tank to engine bay. I have and older A1000 pump with filters, i was going to sump the tank and put that on but should i look into some intank pumps instead? Its a 95% street car and aiming for 1000HP with meth. What do you think?

stangtrader

iTrader: (2)

Id sump it and run a big external for that power level. from my research its too much work to try and make twin intanks fit.

zapp109

iTrader: (13)

yea i guess that was really what i was wondering can it be done or is there a kit...

stangtrader

iTrader: (2)

From what ive seen the bucket in the tank is too small so youd have to cut open the tank modify it then weld it back up.i thought of using a sump but mounting two intanks in the sump so its quiet.a member on here did something similar with a fuel cell

Sarg

iTrader: (6)

What fuel do you plan on running?

zapp109

iTrader: (13)

93 octane with meth

Speedy911

iTrader: (24)

I'd do 2 Bosch Pumps or 2 Walbro 400s, plenty of fuel

redss82

could always run that pump to a surge tank then a big external or two from it

zapp109

iTrader: (13)

I found a bit of a different setup check out this, instead of running a sump setup

http://www.theturboforums.com/thread...nd-pickup-tube

1bad03snake

iTrader: (16)

I'm running an A1000 and sump