branndonw

iTrader: (3)

Not yet lol

Redbull87

iTrader: (3)

Thats freaking cool swap.That squeak would drive me nuts too...it sounds just like my clutch pedal.Im using 02 camaro pedals and found that the squeak was from the helper spring.Sprayed it with some grease and its gone.

branndonw

iTrader: (3)

The squeak is gone and the windshield is fixed lol. I attached the m/c pushrod a little lower on the pedal than the stock location and the push rod was rubbing against the hole on the clutch pedal mount. Went back and made the hole a little bigger and no more squeak.

HioSSilver

iTrader: (8)

Very cool!

Hibs

Love the swap! Still driving good?

branndonw

iTrader: (3)

Thanks! Yep still drives great. No issues.

Hibs

I've made contact! Sweet.... care to share, what the clutch pedal was out of? SSR?

What was the reason for the ECM Switch? And the harness re-pin was just to accommodate the switched ECM?

I would love to duplicate this build.

Hibs

OP, any answers to my questions above?

Chased

this is needs to be a sticky!! It would make me want to keep my SS

Tig

This and if you could answer Hibs to

Seems like a lot of people would love to know, including me.

TheRace1092

maybe i missed it, but were you able to retain the stock 08 tbss e67 and flash it for a manual trans so it controlled the reverse lockout speedo and such? i found a e67 and harness for one and plan to run a t56. id to know before ordering. thanks

TipsyMcStagger

iTrader: (1)

From Post #2.