LC9 Harness Connector Identity
#1
Teching In
Thread Starter
Join Date: Jul 2017
Location: Round Rock, TX
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
LC9 Harness Connector Identity
Hi, Folks! I'm working on the LC9 harness for my '66 Land Rover conversion and I've been diligently following the guides and such from various sites including the LT1swap.com E38 pinouts. I've got everything cleaned up except this one connector that's on the passenger side branch with the O2 sensors. I traced the wires and they go to the black J1 ECM connector, pins 37 (TN/BK) and 41 (YE). According to Brendan's site, these are for the MAF.
When I trace the wires from my actual MAF connector, they go to EMC gray connector.
What is this connector and does it have anything to do with the MAF? Do I need to do anything with J1 pins 37 and 41?
thanks!
When I trace the wires from my actual MAF connector, they go to EMC gray connector.
What is this connector and does it have anything to do with the MAF? Do I need to do anything with J1 pins 37 and 41?
thanks!
#2
Teching In
Thread Starter
Join Date: Jul 2017
Location: Round Rock, TX
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Solved!
Never mind, I'm stupid. It is the MAF connector. I was missing it as it's still attached to the stock air cleaner on the other side of my garage. All good!