JIMB

iTrader: (2)

Can someone direct me to a thread for clutch line details.

If possible I'd like to use the quick disconnect at the slave cylinder and mate the line to a Wilwood master cylinder.

If that's not possible what is the alternative? I'm using a "stock" 2002 Camaro throw bearing.

Regards,

jeromio

Little late, but if you're still stuck, this may help (short on specific details): http://240z.jeromio.com/motorswap/t56.html

JIMB

iTrader: (2)

Thanks the reply. I think I found the answer. Mcleod makes a line that plugs into the quick disconnect on the Camaro slave and then -3 line up to the master.