Mildred Jones

iTrader: (1)

This stuff is new to me. On my ignition controller there are 4 lites Power- Status- Cam- Crank.. I talked to tech support but could not get a straight answer. I know the cam and crank lights blink during cranking but should blink faster once it fires that they appear solid. My cam light will intermittently blink. All other are lit solid. Is this normal or do I have a bad connection? Thanks Lee

G Atsma

Is it reading the OEM cam sensor?

stevieturbo

And there are no instructions ?

slogo

Is it starting? If not, did you connect the Crank/Cam Out connector to the Distributer connector? That part was not clear in the instructions.

Mildred Jones

iTrader: (1)

yes it is the oem LQ4 cam sensor

Mildred Jones

iTrader: (1)

There are instructions but it does not answer my ?

Mildred Jones

iTrader: (1)

yes it does start and run. It does have a surge problem (Light throttle) that has appeared recenetly. I did not notice if the cam light was flickering prior to the surge problem

Mildred Jones

iTrader: (1)

I was hoping someone had the same system and could give me a direct answer. Thanks to all who replied. Lee

slogo

I had that EZ 2.0, pretty sure it blinked when running. Didn't run it long though, maybe 20 or 30 minutes of drive time, never did work right, removed system now I'm finishing up
installing the Holley System, hope you have better luck with yours than I had with mine. Their Tech Support Sucked, I tried to join the tech forum, they haven't
let anybody join in a long time. I started reading reviews on that EZ EFI 2.0 for LS and the reviews was disappointing, so I'm calling it a $1500.00 lesson.

Mildred Jones

iTrader: (1)

Amen to everything you said. I could get an audience with the Pope easier than get through to tech. I should have went with John Spears setup.

slogo

The best thing was, it was bad out of the box, LOOONNNGGG Story later I called Summit to see if I could return it,
no, I could not return it because it has been installed. So I crammed it back in the box and put it on the shelf.