bczee

iTrader: (12)

I need a 5 volt source to power my VSS (Viper T56) and would like to see if I can get the PCM to power it on. Anyone know which Pin I might be able to use ?

99c5vert

Wouldn't any 5V from a 3 wire sensor work? Like TPS or MAP?

Happy Jim

On a 2000 PCM, Red connector,
Pin 20 (Lt Grn/BLK) = VSS Reference Low.
Pin 21 (PPL/WHT) = VSS Signal.

Any use?

Jim

svt

isn't low ref ussually ground? I needed a 5V for my vats bypass module. i used on of the unused gray wires, most of those seem to have +5 volts. Don't recall the exact pin number I used though.

bczee

iTrader: (12)

Thanks.. and sorry.. I should have stated I have a 99 PCM..and trying to get some VSS output to drive a Speedo.

The Viper VSS sensor generates a different signal and is not compatiable with the GM Signal. My other option is to try and machine some sleeve or adpater to use the GM VSS Sensor as the Viper VSS is larger in size.

I think the 99 and 00 PCM are the same ?? guys ?

I removed most of the unused pin/wire.. I will have to which one I can readd ?

bczee

iTrader: (12)

I am using pin #46 to get a 5v source.. that is one thing i need.. will wire it up next, but will have to see about the conversion of the singal to a GM VSS.

let you guys know next time