Omega

iTrader: (5)

Rather than just snipping the female ends off of the C100, C101, and C105 connectors, I want to use the male side too.

I have not found these sold as pigtails anywhere, nor do I know what harness they are on. Would I have to get the other section of engine harness or the dash harness?

poconojoe

iTrader: (43)

C100 female end is Delpi part number 1206-5425
C100 male end is Delpi part number 1204-8253
C101 female end is Delpi part number 1206-5426
C101 male end is Delpi part number 1206-5648
C105 female end is Delpi part number 1204-7937
C105 male end is Delpi part number 1205-2454

You'll have to go to an electrical supplier, like www.mouser.com
to find the connectors, seals and terminals

waynehartwig

Very cool! Do you know if they come with the pins?

poconojoe

iTrader: (43)

No When you look up the connector, you can find out which pins and seale it uses. It takes a little to understand which pins to use, since it uses metric wire sizes. I just down and pick pins and seals until I find ones they stock

Rodder

iTrader: (2)

I bought a connector kit from Caspers.