radiator hose help stock 69 camaro
 

am going with a ls1 motor in a 69 camaro but goin to try the stock 69 radiator 1st.. but what hose's do i use to hook the motor up? i can find what ones to use if i use a ls1 radiator but not a stock 69 radiator. any help would be good. thanks jason

Here are some splicers and transitional splicers that can help when using a radiator that uses different hose sizes than the LSx:
http://www.jagsthatrun.com/Pages/images/Coll1.jpg

See this link:http://www.jagsthatrun.com/Pages/Par...eSplicers.html

Thanks

Does anyone know a part number to a hose that will work from the stock Radiator to the ls1 r what did u all do with the same set up?

I saw a guy on here with an old camaro that just used the stock LS1 camaro upper hose.

For my Nova, i just got a couple 1.5" u-bends cut and formed as needed, then welded it all up and used a couple pieces of straight hose to connect it to the rad and waterpump.

Found these on NastyZ28



Upper: Gates part #22352
Lower: Gates Part #20734


Some trimming may be required

is that with the stock 69 radiator R with the ls1 radiator

Those fittings shown above will also give you an easy place to put a mech temp sensor and the steam vent which can be handy.

I used goodyear 62426. It was a little smaller than my upper, but I sprayed some WD-40 on and it slid right on.

What air cleaner did u use? I will be going with one of the t's posted above for the cross over tube!