Help with DBW / TAC function I'm getting fuel, Spark, ignition, but it won't run because the throttle body has zero movement. Engine fires up for 1 second until ths TB gets sucked shut. My problem is zero TB response. 94 Caprice Swapping in a 04 Yukon LQ4 6.0 I'm running the stock 04 Yukon Throttle Body TAC module PCM (vats tuned out) MAF Also running Truck pedal sensor (bought another and the voltages match so I'm fairly certain it's correct) Ebay extended vette tac to pedal wire (I crosswired E to J to match truck wiring) Ebay intake tube Ebay swap harness (everything pretty nice, confirmed others install and function before purchase) 2 block ground straps 1 battery Ground strap 1 harness ground strap So I have voltage at the pedal. ive tested the TB wires, I've also tested the TB and it flips and flaps with 12v to yellow and brown. my tuner says nothing on his end should affect the DBW. NO CODES ARE THROWN How do i go about testing the TAC module and wiring harness to eliminate these possibilities? I'm at the end of 3 days of searchable videos and threads about this Thanks for any help |
Originally Posted by Alpha_numeric44
(Post 20554489)
I'm getting fuel, Spark, ignition, but it won't run because the throttle body has zero movement. Engine fires up for 1 second until ths TB gets sucked shut. My problem is zero TB response. 94 Caprice Swapping in a 04 Yukon LQ4 6.0 I'm running the stock 04 Yukon Throttle Body TAC module PCM (vats tuned out) MAF Also running Truck pedal sensor (bought another and the voltages match so I'm fairly certain it's correct) Ebay extended vette tac to pedal wire (I crosswired E to J to match truck wiring) Ebay intake tube Ebay swap harness (everything pretty nice, confirmed others install and function before purchase) 2 block ground straps 1 battery Ground strap 1 harness ground strap So I have voltage at the pedal. ive tested the TB wires, I've also tested the TB and it flips and flaps with 12v to yellow and brown. my tuner says nothing on his end should affect the DBW. NO CODES ARE THROWN How do i go about testing the TAC module and wiring harness to eliminate these possibilities? I'm at the end of 3 days of searchable videos and threads about this Thanks for any help "Ebay extended vette tac to pedal wire (I crosswired E to J to match truck wiring)" i am not sure what that is but it sounds sketchy. Its the only thing that isnt stock in your configuration. you shouldn't even have to start the engine, you should be able to turn ignition on, then press the pedal and see throttle body movement. if that doesn't work, you have an issue. time to pull out a scanner and start looking at data for the gas pedal sensors and the throttle position sensors. |
All times are GMT -5. The time now is 05:37 PM. |
© 2024 MH Sub I, LLC dba Internet Brands