The "Grocery Getter" entered the single digit club!!!
#1
The "Grocery Getter" entered the single digit club!!!
Well we finally got some dry weather on a day when the track was open. It was getting crowded quick and was afraid the track prep was going to go south pretty quick, but we got a few passes in. After a few tuning passes and operational errors we got the car dialed in. It was leaving straight and the mph was up good with an AFR of 12.8-12.9 and only 26* of timing it was ready.
Once we arrived we just swapped to the slicks and dropped the front shocks a few clicks and we were race ready and doing it through a set of Borla XR1s running Grocery store 93 octane unleaded pump gas.
I strapped the little lady in the pilot seat and the rest is history
She rolled in a little deep so it cut the 60ft down to weak 1.324, but still managed a 9.96@133.55mph. It's got 9.8s in it since we've pulled 1.29 60fts in worse air conditions.
We were pumped to say the least. Not bad for an all motor, pump gas daily driver huh?
We haven't been driving it on the street as much because I've been leaving the race seat in and the passengers seat out, but since we aren't 9's legal, I'll put them back in and she can enjoy it more. We just wanted to prove it could be done without a ton of compression and race fuel. I'll be trying a few max effort passes with a more aggressive tune and some of the higher end oxygenated fuels that might show us what the car has in it.
The car has an HKE iron block 408 with heavily tweaked "Greg Good" 5.3 heads. Greg recenty went back and massaged them for us during the off season and added a bit more power to the beast. HPE pulled the heads the same day I dropped the car off and got it back on the road the day after they got the heads back. How's that for customer service?
Here's a video for ya!
Once we arrived we just swapped to the slicks and dropped the front shocks a few clicks and we were race ready and doing it through a set of Borla XR1s running Grocery store 93 octane unleaded pump gas.
I strapped the little lady in the pilot seat and the rest is history
She rolled in a little deep so it cut the 60ft down to weak 1.324, but still managed a 9.96@133.55mph. It's got 9.8s in it since we've pulled 1.29 60fts in worse air conditions.
We were pumped to say the least. Not bad for an all motor, pump gas daily driver huh?
We haven't been driving it on the street as much because I've been leaving the race seat in and the passengers seat out, but since we aren't 9's legal, I'll put them back in and she can enjoy it more. We just wanted to prove it could be done without a ton of compression and race fuel. I'll be trying a few max effort passes with a more aggressive tune and some of the higher end oxygenated fuels that might show us what the car has in it.
The car has an HKE iron block 408 with heavily tweaked "Greg Good" 5.3 heads. Greg recenty went back and massaged them for us during the off season and added a bit more power to the beast. HPE pulled the heads the same day I dropped the car off and got it back on the road the day after they got the heads back. How's that for customer service?
Here's a video for ya!
#5
LS1 Tech Administrator
iTrader: (14)
Way to go James and Sheila! Killer milestone!
__________________
2013 Corvette Grand Sport A6 LME forged 416, Greg Good ported TFS 255 LS3 heads, 222/242 .629"/.604" 121LSA Pat G blower cam, ARH 1 7/8" headers, ESC Novi 1500 Supercharger w/8 rib direct drive conversion, 747rwhp/709rwtq on 93 octane, 801rwhp/735rwtq on race fuel, 10.1 @ 147.25mph 1/4 mile, 174.7mph Half Mile.
2016 Corvette Z51 M7 Magnuson Heartbeat 2300 supercharger, TSP LT headers, Pat G tuned, 667rwhp, 662rwtq, 191mph TX Mile.
2009.5 Pontiac G8 GT 6.0L, A6, AFR 230v2 heads. 506rwhp/442rwtq. 11.413 @ 121.29mph 1/4 mile, 168.7mph TX Mile
2000 Pewter Ram Air Trans Am M6 heads/cam 508 rwhp/445 rwtq SAE, 183.092 TX Mile
2018 Cadillac Escalade 6.2L A10 Pat G tuned.
LS1,LS2,LS3,LS7,LT1 Custom Camshaft Specialist For custom camshaft help press here.
Custom LSX tuning in person or via email press here.
2013 Corvette Grand Sport A6 LME forged 416, Greg Good ported TFS 255 LS3 heads, 222/242 .629"/.604" 121LSA Pat G blower cam, ARH 1 7/8" headers, ESC Novi 1500 Supercharger w/8 rib direct drive conversion, 747rwhp/709rwtq on 93 octane, 801rwhp/735rwtq on race fuel, 10.1 @ 147.25mph 1/4 mile, 174.7mph Half Mile.
2016 Corvette Z51 M7 Magnuson Heartbeat 2300 supercharger, TSP LT headers, Pat G tuned, 667rwhp, 662rwtq, 191mph TX Mile.
2009.5 Pontiac G8 GT 6.0L, A6, AFR 230v2 heads. 506rwhp/442rwtq. 11.413 @ 121.29mph 1/4 mile, 168.7mph TX Mile
2000 Pewter Ram Air Trans Am M6 heads/cam 508 rwhp/445 rwtq SAE, 183.092 TX Mile
2018 Cadillac Escalade 6.2L A10 Pat G tuned.
LS1,LS2,LS3,LS7,LT1 Custom Camshaft Specialist For custom camshaft help press here.
Custom LSX tuning in person or via email press here.
#6
On The Tree
iTrader: (1)
Join Date: Jan 2006
Location: Houston
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
Way to be James! You stuck to your guns on what you wanted out the car, & after some time & a lot of hard work, your there! Congrats once again to you & Mrs Sheila. Did tech dept say anything, or did you slide this time?
Trending Topics
#11
She slid right through the tech. They might yell at me, but they love her to death out there.lol. I'm really glad we stuck to our drivability goals too.
Yeah patrick it doesn't seem like that long ago we were struggling to get into the 10s.lol.
I'll never give up my 4L60E. It's da sh*t!!!
Yeah patrick it doesn't seem like that long ago we were struggling to get into the 10s.lol.
I'll never give up my 4L60E. It's da sh*t!!!
Last edited by TXCAMSS; 01-30-2007 at 07:07 PM.