MSD 2 Step & 2001 TA 2-wire clutch switch
#1
CARTEK Racing
Thread Starter
iTrader: (13)
Join Date: Nov 2001
Location: East Brunswick, NJ
Posts: 2,182
Likes: 0
Received 0 Likes
on
0 Posts
MSD 2 Step & 2001 TA 2-wire clutch switch
Could not find which tire was 12V. Read on here that the dark green was the one I needed to tap into. 2 step not turning on with clutch depressed.
I had to use a relay with the LPE LNC2 that I had, is the MSD box the same story?
Thanks!
I had to use a relay with the LPE LNC2 that I had, is the MSD box the same story?
Thanks!
#6
CARTEK Racing
Thread Starter
iTrader: (13)
Join Date: Nov 2001
Location: East Brunswick, NJ
Posts: 2,182
Likes: 0
Received 0 Likes
on
0 Posts
its a 2-wire connector and it has a green and a purple with something wire. i think i found a wiring diagram, but it needs a 87a relay. which i have, so i'll wire it in. it worked with the LPE one. i don't think the switch runs on 12v so there is no way it can give a 12v output to the 2step.
Trending Topics
#10
9 Second Club
iTrader: (10)
I wired mine right off the pcm, didn't have to go through the firewall. Blue PCM # 32 Grey wire Clutch Pedal Position Switch Signal. Everything functions as normal and the 2 step is only active when the pedal is to the floor.
http://www.ls2.com/boggs/torques/00pinpcm.htm
http://www.ls2.com/boggs/torques/00pinpcm.htm
#11
Banned
iTrader: (47)
Join Date: Oct 2011
Location: Wisconsin
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
I wired mine right off the pcm, didn't have to go through the firewall. Blue PCM # 32 Grey wire Clutch Pedal Position Switch Signal. Everything functions as normal and the 2 step is only active when the pedal is to the floor.
http://www.ls2.com/boggs/torques/00pinpcm.htm
http://www.ls2.com/boggs/torques/00pinpcm.htm
what wire did you use... the solid blue or blue/white strip?
thanks!
#13