Ron@Vengeance

iTrader: (51)

Finished this one up Friday guys. Very cool combo IMO...

Car-1999 C5/A4

Modifications:

Proline/Vengeance 347 shortblock- Stock LS1 Block/Stock crank/Callies Rods/Diamond Pistons/TNT Ring Pack/ARP Main Studs
STOCK 241 Casting GM Cylinder Heads
Upgraded TEA Dual Spring Kit
GM LS6 Camshaft
ARP Head Studs
GM LS6 Intake
Stock Throttlebody- Ported
RPM Level VI A4 Transmission
Yank 3200 Stall
STOCK Catback

APS Twin Turbo System
APS Fuel System
Installation/Tuning by Vengeance Racing
100% Stock Drivability
100% Stealth!!!
Pump Gas
NO METH
Air Fuel-11.4-11.6
Timing-17*


491/539 graph is 7lbs
655/656 graph is 12lbs

CoastieWS6

iTrader: (1)

Nice numbers!!

FSTPOON

As usual nice #'s and build Ron!!!

allngn_c5

iTrader: (3)

Whats up Melissa, nice meeting you !!

Back to business. Awesome job Vengeance !! I'll bet that tranny is crying its eyes out with all the hp/tq it has to take now that you guys have transformed the motor into a TT beast !!

eb02z06

iTrader: (18)

Good job as always guys!

airforcemanss

iTrader: (23)

omg! hey ron what k member do you use for the aps build? i just bought the bmr one but its not the turbo one. im building in stages for one of these bad boys can you pm me a figure so i know what to expect when i pay the note off? man o man i am jealous

Johnnystock

iTrader: (6)

hell torque!!

SSPRAYD CAMARO

Man... this sounds like a pretty sweet ride. Very impressive #s I bet it is a blast to drive. There is only one thing I would change (one in every crowd I know) put this set up in an f-body sure to break hearts!!!! Awsome job.

AGRV8TD

iTrader: (1)

damn killer #s on stock heads!!!

bad95killer

Damn those sick numbers Ron

peace

Ron@Vengeance

iTrader: (51)

Not too shabby for the combo

Y2K WS6

iTrader: (33)

Good numbers, thanks for posting. I'm going with a very similar setup but with bigger cam, open exhaust. I'm quite anxious.

WSsick

iTrader: (13)

if you can call a vette a sleeper, than that is one. badass!

PewterScreaminMach

iTrader: (7)

Awesome numbers for that basically stock H/C/I setup! Hopefully your customer doesn't have the infamous APS shitty turbos issue a few months down the road.

Dutchman427

iTrader: (1)

Wow, Very nice numbers.

Fbodyjunkie06

iTrader: (10)

Did you guys fix the inlet problems collapsing that were brought up about this kit or is 12 lbs not enough to negate them to close as some where? As usual though great numbers Ron!

MYSTIC-1SC

iTrader: (14)

very nice numbers, and with the stock heads too

Spectre86

iTrader: (42)

just one question. why stock exhaust? and stock heads? and 241s at that.

man that dyno graph is wicked.... looks like someone droped a sledge hammer.. powerband just goes damn near strait up.