Just ordered the Streetsweeper cam, what do you think my HP will be?
#21
any cam can be made to perform is the point though...
my baby 230/230 cam only first time out ran 11.13 at 121mph...
good luck with the cam though I am sure it will work out good...
my baby 230/230 cam only first time out ran 11.13 at 121mph...
good luck with the cam though I am sure it will work out good...
#22
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Dec 2002
Location: Syracuse, NY
Posts: 1,349
Likes: 0
Received 0 Likes
on
0 Posts
Im sure I will like it. From looking around, no one has complained about it but then again there arent that many people running that exact cam. Some of the other cams specs are close.
#23
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Dec 2002
Location: Syracuse, NY
Posts: 1,349
Likes: 0
Received 0 Likes
on
0 Posts
I just dropped the car off at New Era for the install and tune. I also asked for a dyno run with the cutout open and closed, I have the flowmaster catback everyone hates
It should be done thursday or friday and I will post the results
It should be done thursday or friday and I will post the results
#25
Teching In
Join Date: Feb 2010
Location: Rochester NY
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Dose anyone know what type of Heads would match that cam best.
Just like the title says, I was think 410 rwhp through my stock 10 bolt, car is an m6
Here are the specs
Specs Int Exh
Duration @ .050 236 240
Lift .630 .612
LSA : 111
Mods are:
BBK SSI intake
BBK 85 mm TB
GM 85 mm MAF
Fast toys ram air
LPP headers and catted y pipe
Cutout
Here are the specs
Specs Int Exh
Duration @ .050 236 240
Lift .630 .612
LSA : 111
Mods are:
BBK SSI intake
BBK 85 mm TB
GM 85 mm MAF
Fast toys ram air
LPP headers and catted y pipe
Cutout