davered00ss

iTrader: (4)

Took about 10 min. 1st try, I still need to drill the center hole to the right size & get the right size threaded rod. I may just start fresh tomorrow, and try to make a cleaner looking one. Although these will still work.

Slowhawk

iTrader: (12)

All you need is a 1- 8mmx1.25 -2.5" long. Those pieces look fine,just drill the holes out bigger.

davered00ss

iTrader: (4)

Thanks Don. I traced yours. I just drilled pilot holes because I did not have a lot of time.

davered00ss

iTrader: (4)

2 black ones are done. Not sure if I'll use them or scrap them. One is stainless steel is a work in progress.