2010 Camaro Dyno results
09-25-2009, 05:43 PM
#1
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Jan 2004
Location: Port St. Lucie,Florida
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
2010 Camaro Dyno results Decided to get a baseline today just to see where I'm at. Went to MacDonald motorsports in Stuart. Got it right up there with not much cool down. It made 379.50 and 380.58 to the wheels bone stock. I was very impressed to say the least. He cut it off a little early-6000 RPM, but I couldn't imagine finding any more above that. This was on a Dynojet. That's about 450 or so at the flywheel I think. Anyway, I'm very happy and can't wait to see what the bolt-ons will do. Sean
09-26-2009, 08:40 AM
#4
TECH Addict
iTrader: (21)
Join Date: Dec 2006
Location: Port Saint Lucie,Florida
Posts: 2,767
Likes: 0
Received 1 Like
on
1 Post
Can,t wait for the cool weather to put mine on his dyno.It should be about 430 to the tires on Bruce,s dyno because Mike told me his is about 3% off and i have the Cold Air intake now also.Sean let me know when your going to take her to PBIR .I went last night and waited 4hrs to run but the place was a mess as always so i just left.
Joe
Joe
09-26-2009, 12:41 PM
#6
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Jan 2004
Location: Port St. Lucie,Florida
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Hey Joe. I was thinking I would just wait to go to the track when I do some mods. I may just go the route you are going with the cai and headers/tune and then add the maggie later. Of course, if the weather turns cool, I may be tempted to go out to the track. I'll let you know for sure.
