blackbirdls1

iTrader: (5)

Anyone local can do this without causing damage?

LS6427

iTrader: (2)

I BFH my inner wheel wells to fit my 335 tires......they aren't on yet. I have to still cut the bump stop mount out and those 3 ridges above it. Then weld in a flat 16 gauge steel plate. Install offset LCAs and put them on.

I'm not rolling my fender lips.....no need.

.

blackbirdls1

iTrader: (5)

My 315s are on, but a slit or slice of rubber was taken out by the fender i believe. Would rolling be necessary? I dont have a PHB. If the BFH mod is needed what is the method used?

blackbirdls1

iTrader: (5)

Bump anyone?

HCI2000SS

iTrader: (2)

What is the offset on your 315's?

Captain Slow

If it's lowered you'll need the adjustable phb for sure. I had to roll the fenders, cut the bump stop mounts and do the bfh mod for 315's. There's a few pics of where I had to hammer in this thread.

https://ls1tech.com/forums/chevrolet...-ss-build.html

TheTinMan

If you search craigslist theres a guy that will come to you and do it at your house. I had him do the fenders on my CTS-V when I had it. He did a great job and was only like $50.