Moter

iTrader: (20)

Hey folks,
I am putting together a 5.3 with a LS1 intake and a 72mm turbo,I have aftermarket rails and 60 lb injectors. I am looking for ideas of how ppl here have routed fuel lines to and from the Fuel pressure regulator and how are you mounting the regulator.


Thanks!

Scott

jt76

iTrader: (10)

Here is a pic from when i had it mocked up... -8 split into two -6 into the back of both rails. -6 crossover in the front with the -6 drain going out the bottom of the reg.

BottleFedZ346

iTrader: (17)

Hmmmm, i might steal that setup from ya Jt!

a-low

iTrader: (26)

Very nice!

35thsscamaro02

Moter

iTrader: (20)

Thank you jt76. Ive been trying to fiqure a way to this and your picture gave me some good ideas. Btw...how did you go about splitting the -8 to -6 ?

Thanks

ittwgn

hi , here,s my setup i knew i had pics stored!!! line on back of regulator joins to original fuel line and acts as return line to tank!!!! cheers

jt76

iTrader: (10)

I just used a "y block" fitting -8 in and two -6 out right behind the brake booster. Heres a tip learn from my mistakes lol you will need Two 90* fittings off the back of the rails, not a lot of room back there

Moter

iTrader: (20)

Right on! Thanks

My application will not have any problems with room...its going in a 50`s chevy..