ls1curt

iTrader: (31)

This will be a full street car, pwr steering, pwr. brakes, etc.
It is slckstr96's car that made the switch to the dark side from the LT1.
I'll be doing the turbo kit and tune.

The setup is:

Iron 6.0 based 370
317 heads
Tick stage 2 cam
Holley Mid-rise intake
Eboost boost controller
Twin 255 pumps
80lb injectors
retains stock radiator/fans
Alkycontrol dual nozzle meth kit
truck manifold based turbo kit - 2.25" hotside/3" coldside/5" downpipe
s480/96/1.32ar
Twin 39mm PTE gates
Tial 50mm bov
ebay 4" a2a
th400 w/ PTC 9.5" converter
Strange s60

Chassis is all UMI, BMR, Midwest components

Hoping to put it pretty deep into the 8's

ls1curt

iTrader: (31)

Intercooler mounted




Lower radiator support

ls1curt

iTrader: (31)

Turbo location mock-up

ls1curt

iTrader: (31)

Turbo mounted

ls1curt

iTrader: (31)

Coldside and downpipe started

Ratical

iTrader: (82)

Looking great Curt! Do you know what brand those valve covers are?

When are you going to turbo the Barbie Jeep? Lol

ls1curt

iTrader: (31)

Thanks. I believe they are the Holley's.

Ha the Jeep is next.

Gunters96lt1

iTrader: (21)

beautiful Camaro. Awesome build.

ls1curt

iTrader: (31)

bumper trimmed for IC




and the rest of the hotside components in

93camaro_zzz

iTrader: (13)

Should be a fun build! I will be interested to see how fast it goes. My setup is identical. Cast s480, 370ci, and th400. So far I have run the time in my sig. Didn't get a great 1/4 mile time when I went, but the car should run about an 8.70 as it sits. I am also making some chances to hopefully push it much further into the 8's. Good luck!

drumbo87

iTrader: (4)

What are your plans beyond the exhaust coming off of the downpipes? Taking it to the rear or out the passenger side?

ls1curt

iTrader: (31)

It will be 5" out the passenger side bumper

HaterMaker

How much boost and what fuel do you plan on running with it? And what year 6.0 are you using?

323z

Looking good. I swear fox-bodys are like girlfriends, everybody has 1 off on the side..

ls1curt

iTrader: (31)

It will be on 93+meth. Probably going to end up around 18-20 psi. Not sure on year of the motor. It's forged pistons/rods though.

ls1curt

iTrader: (31)

Downpipe done. Just needs final trimming.



Cold side complete

tim wellington

nice build .you are not worried about exhaust heating it up.raising i.a.t

ls1curt

iTrader: (31)

thanks. No there's still quite a bit of clearance between the dp and cold pipe. The downpipe will be ceramic coated as well.

Nitroused383

iTrader: (10)

Is that an aluminum downpipe? Looking good Curt!

TURBOLSBIRD

iTrader: (5)

Great fab work. Real clean setup!