688 rwhp and 697.9 ft lbs of torque with a D-1SC at 14 psi
#81
TECH Addict
iTrader: (53)
Originally Posted by Mike2002
Thanks! I hope to get a set of the Kooks stepped headers and GMMG exhaust soon. I can't stand the rasp it makes right now.
Good luck with the car. I'm sure it will be fun.
Andy
#83
FormerVendor
Join Date: Mar 2006
Location: Hell AFB
Posts: 1,540
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Mike2002
You can definitly hear that stage 5 clutch at take off. I can't wait to get this puppy back.
#85
TECH Junkie
iTrader: (10)
Originally Posted by White.Lightning
Rasp sucks! I like how my FLP LT's, ORY, and Hooker sounds. Once the D1 is on the car, I'll try and get a video to compare exhaust notes
Good luck with the car. I'm sure it will be fun.
Andy
Good luck with the car. I'm sure it will be fun.
Andy
Andy we made good power with that exact exhaust setup, stock motor at 8 psi D1SC- 545 to the wheels
#94
The 4" aluminum elbows that I ordered showed up yesterday for the air filter intake. We were seeing the 4 ply 4" 90 degree elbow suck itself closed during the runs, which then caused our wide band 02 sensor to foul out.
We made some more pulls on the car yesterday, and it appears that the combination is maxed out, as we were not seeing anymore horsepower. It could be one of several factors, or a combination. We are using a rather mild camshaft, mild when you're talking about 700 rwhp. The D-1SC blower is close to it's max impeller speed, it may be maxed out as far as airflow goes. We are using the stock ATI supplied brackets, no slippage is evident, but I'm sure there is some, almost has to be. Bob
We made some more pulls on the car yesterday, and it appears that the combination is maxed out, as we were not seeing anymore horsepower. It could be one of several factors, or a combination. We are using a rather mild camshaft, mild when you're talking about 700 rwhp. The D-1SC blower is close to it's max impeller speed, it may be maxed out as far as airflow goes. We are using the stock ATI supplied brackets, no slippage is evident, but I'm sure there is some, almost has to be. Bob
#98
Originally Posted by Spade
Hey Bob were did you order the Aluminum elbows from? I was going to go ply but not now since you posted about them sucking shut.
#99
Originally Posted by Mike2002
EPP rocks!! This car is wicked. I know there are faster but for me this car flys!! Thanks again Bob. I will post some vids as soon as the track opens.