Heads came back from machine shop Hey guys, It's been a while but I am now finding some time to work on my car. My heads came back from the machine shop and they look great. I had a valve job done with new seals, had the combustion chambers polished, and had my 918's and titanium retainers installed. I can't really tell if they were milled or not... I didn't ask for it but I'm going to see if they did it anyway. Check it out! http://www.buyrcars.com/IMG_4177smallest.jpg http://www.buyrcars.com/IMG_4176smallest.jpg -Dave |
Clean as hell lookin set of heads bud. You almost done with your rig now? |
looking good, if they did mill em they probably just decked them to make sure the surfaces were perfectly flat. When I had my 317's clean up, they decked em to make sure they mounted up and sealed perfectly....well thats what they told me at least:D |
Probably milled .010" for straightness. I would HIGHLY doubt a company would mill a set of heads w/o permission since there are p-v issues to consider when doing that. |
Yea, just because I have a little bit of room to work with on my CR (I'm around 8.5:1) doesn't mean everyone does. I haven't had a lot of time to work on my car until recently.. now I have a little more time and I am ready to go! It's still a long way from burning gas, but getting closer. I have most of the parts I need to get it running NA. |
All times are GMT -5. The time now is 03:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands