Dyno'd the blower setup today!
 

640rwhp 601rwtq at 10psi.

Anyone know where to get a slightly bigger 8 rib crankshaft pulley? :devil:

http://i80.photobucket.com/albums/j1...no04-12-08.jpg

Nice numbers....Inovators West has a 8" crank pulley....

Any idea what they charge? No prices on website.

ASP could make any pulley you want too. They made all of mine.

The innovators balancer is only for the C5 vette.

ASP can custom do a pulley in any offset or size, i believe its around 375-400.

You only want around a inch bigger due to being close to the water pump.

What kind of boost you running these days?

a4 or m6? nice numbers

Damn!! Still using the stock 10 bolt!!! Nice!!! Bada$$ color btw, rarely see it on 98-02's

We have the 8 rin Alt, tensioner, & PS pulleys...
http://i262.photobucket.com/albums/i...lleyKit002.jpg

Lookin a bit lean up top.
I would be carefull with that especially since you did this on a dynojet.
It's gonna be even leaner on the street.

It's a 6 speed.

10 psi boost with a 7.65 crank and 3.45 blower pulley spinning the motor to 6k rpms.

We're doing the fine tuning now that we have that dyno graph to look at. We're going to lean it out a little here, richen it up there....

Thanks for the compliment on the color. I can't say I've seen another 98+ T/A with this color. Costed me a pretty penny to get the ram air hood matched to my car...they ended up getting into the fenders and doors for proper blend. You cannot tell the hood was originally red except a few tiny spots where rockchips damaged it.

Hey you got the v-8 in that audi?

Vid here..... http://www.youtube.com/results?searc...2&search_type=

This is an F Body, where the blower pulley is mounted outboard of the balancer. Do you offer an oversize pulley for this combination? Thanks! Bob

Not yet, but it's in the works.