O2 sensor replacement

Reply Subscribe

Thread Tools

Search this Thread

Aug 20, 2016 | 12:47 AM

Chevyss20001

Thread Starter

Teching In

Joined: Aug 2016

Posts: 1

Likes: 0

O2 sensor replacement

I have lt headers and had the Bosch 13111s on my previous car so I decided to put a set on this one. When I installed them I fired it up and it would barely run, idle way low and multiple misfires. Put the old ones back in and it runs fine. Any ideas on what is going on?

Aug 20, 2016 | 11:57 PM

JOHNNY59

11 Second Club

iTrader: (398)

Joined: Jul 2009

Posts: 1,280

Likes: 35

Quote:

Originally Posted by Chevyss20001

Bosch sucks, switched to Denso O2's and never had a problem.

Aug 21, 2016 | 07:02 AM

95wannabe

TECH Enthusiast

iTrader: (20)

Joined: Aug 2009

Posts: 505

Likes: 13

From: Maryland

Anyone have an opinion on the NGK's?

Aug 26, 2016 | 07:02 AM

Old Geezer

TECH Senior Member

iTrader: (3)

Joined: Jun 2004

Posts: 5,639

Likes: 71

From: GA, USA

1. If this is when the engine is cold, it doesn't use the O2's until closed loop temp is reached.
2. Different wire/pin location in the new sensor plug?
3. Data logs?

Aug 28, 2016 | 10:13 AM

Ntoxicaytd

Teching In

Joined: May 2016

Posts: 18

Likes: 0

From: Nebraska

I'm assuming you deleted your rear 02s. Personally I repinned the harness so I could plug my stock sensors into the downstream plug. There's a few write ups on it around here

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last