LS1TECH - Camaro and Firebird Forum Discussion

Gears & Axles Driveshafts | Rearends | Differentials | Gears | 12 Bolt | 9 Inch | Dana

3 ch. axles in a 4 ch rear

Thread Tools
 
Search this Thread
 
Old 02-13-2009, 03:42 PM
  #1  
TECH Enthusiast
Thread Starter
iTrader: (1)
 
shtnfrds's Avatar
 
Join Date: Aug 2008
Posts: 726
Likes: 0
Received 0 Likes on 0 Posts

Default 3 ch. axles in a 4 ch rear
if I put 3ch. axles in a rear that is a 4 ch rear, would it work? assuming i dont want to retain abs or trac?
shtnfrds is offline  
Reply Like
Old 02-13-2009, 03:45 PM
  #2  
10 Second Club
iTrader: (64)
 
dschmittie1's Avatar
 
Join Date: Aug 2005
Location: York, PA
Posts: 2,344
Likes: 0
Received 2 Likes on 2 Posts

Default
The only difference in the axles is that they can have the rings on them. You can swap the axles between the rears.
dschmittie1 is offline  
Reply Like
Old 02-13-2009, 03:56 PM
  #3  
10 Second Club
iTrader: (27)
 
RsSean's Avatar
 
Join Date: Feb 2008
Location: Pensacola, FL
Posts: 2,182
Likes: 0
Received 2 Likes on 2 Posts
Default
Yes they can. I did the exact oppisite with mine. Found a set of Moser four channel axle and stuck them in my 3 channel axle works well.
RsSean is offline  
Reply Like
Old 02-13-2009, 04:17 PM
  #4  
12 Second Club
 
nemss1's Avatar
 
Join Date: Jun 2008
Location: Edmond, OK
Posts: 2,587
Likes: 0
Received 2 Likes on 2 Posts
Default
seeing u dont want to retain ABS or TCS, then that would work perfect
nemss1 is offline  
Reply Like
Back to Subforum
Gears & Axles
View Next Unread
Problem with sway bar on 12 bolt




Advanced Search

All times are GMT -5. The time now is 06:45 AM.