LSXJerry

Hello all,

I am currently doing a project on the 99 TA. I am replacing the bearing races in the rear end. When I was about to install the inner bearing race, I did not have the size on the installer kit I bought. What size do I need to buy for this? I am not sure if it comes in a kit or if I can buy by itself. I have not been successful in trying to find out. Bearing race part # is M86610. I appreciate it!

FirstYrLS1Z

iTrader: (4)

https://www.summitracing.com/parts/t...SABEgJC4fD_BwE

LSXJerry

Do you know what the size is for the plate on the bearing race installer kit?

FirstYrLS1Z

iTrader: (4)

Oh, I thought you were looking for where you could get a new race.

SAPPER

iTrader: (10)

When you say INNER race, are you referring to the pinion bearing?
All you need is the basic race and seal installer kit available at any parts house or harbor freight.
Only other races are the side bearings and they just sit on the bearings and fit in with the rest of stack.

Z28SteveA4

iTrader: (16)

Just as a tip put the race in the freezer for a couple hours before you go to install them into the rear. They go in much smoother