Need a couple measurements off a Moser 9” for a 4th Gen, please..
09-13-2017, 09:27 AM
#1
Teching In
Thread Starter
Join Date: Sep 2017
Location: Dallas TX.
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Need a couple measurements off a Moser 9” for a 4th Gen, please.. Need a couple measurements off a Moser 9” for a 4th Gen, please..
I have a Moser 7230 torque arm bracket and am looking on mounting to a 9” housing in the same way that is done by Moser. There are three mounting points secured by three ¾ “ fine tread Grade 8 bolts. These bolts screw into 3 tubes that are welded to the housing . I would appreciate a couple of measurements if someone that has a Moser 9” for a fourth Gen..
1. What is the diameter of the mounting point (tubes welded to housing)? Looking a pictures I have seen, they look to be 1.25” diameter
2. I assume they are hollow (drilled trough)? Are they threaded end to end? and what is the wall thickness, guessing .281”?
3. How far to these tubes protrude from the 3ed member mounting face of the housing?
Any info would be greatly appreciated.
I have a Moser 7230 torque arm bracket and am looking on mounting to a 9” housing in the same way that is done by Moser. There are three mounting points secured by three ¾ “ fine tread Grade 8 bolts. These bolts screw into 3 tubes that are welded to the housing . I would appreciate a couple of measurements if someone that has a Moser 9” for a fourth Gen..
1. What is the diameter of the mounting point (tubes welded to housing)? Looking a pictures I have seen, they look to be 1.25” diameter
2. I assume they are hollow (drilled trough)? Are they threaded end to end? and what is the wall thickness, guessing .281”?
3. How far to these tubes protrude from the 3ed member mounting face of the housing?
Any info would be greatly appreciated.
