adrian650

Hey new to the forums but been lurking around for some time. I currently have a 8.8 out of a Crown Vic disassembled. I was wondering if any one could help and guide me in the right direction for a torque arm mount. Reason i chose this rear end is because of its length being similar to the stock f body rear end. Will a hiltsy torque arm mount work? Anyone out there have a Crown Vic rear in their car that can help? Sorry i know this topic has been beat to death but i just can't find an answer after months of searching.

80/TA/LT1

iTrader: (2)

adrian650

Have you tried it and had success?

80/TA/LT1

iTrader: (2)

adrian650

What did your buddy do about the 3 bolt holes that are missing on the passenger side of his rear end?

80/TA/LT1

iTrader: (2)

Cole Train

iTrader: (30)

my 8.8 is from an Explorer. 3.73's and now upgraded with Ford Racing carbon clutch packs. I had a fabricator called TNT from OK do my fabrication. i built and set it up after i got it back

adrian650

what did you do to relocate the fill hole since the hiltsy mount will block the current fill hole ?

enyo

Get a ford mustang cover that has fill, drain, and vent ports on ebay.