ssdriver27

iTrader: (15)

ok Im in the middle of rebuilding or rather upgrading my stock 10 bolt and the damn c clips will not come out. any suggestions ? tried a magnetic scope, tried prying on the shaft with a screwdriver no such luck. tried getting in there with my fingers same thing they just dont want to come out.

jimmyblue

iTrader: (11)

I think you need a buddy to push the wheel in toward
the pumpkin, then the clip should slip free.

99PontTA

if you have traction control you need to remove the sensors out on the backing plates so the axles can move in far enough.

cablebandit

iTrader: (37)

when you have the axles in far enuff, they will FALL out as you will see when you try to put them back in

ssdriver27

iTrader: (15)

aaahhhhhh thanks a million .

SUTTERERMAN85

iTrader: (42)

i had the same prob. took me like and hr to see that the traction control sensors were in the way. i felt like a dumbass

Mike2000Z28

The same thing happened to me, its insane that I couldn't figure out the sensors were holding me up yet I was able to replace the axles and the abs/tcs aluminum ring on my new axle.