Necessary programming after 2.73 to 3.42 swap?
#1
On The Tree
Thread Starter
iTrader: (7)
Join Date: Sep 2003
Location: San Diego / Carmel CA
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
Necessary programming after 2.73 to 3.42 swap?
Posted this up in the Automatic Trans forum too...
Does anyone know exactly what programming is needed following a gear swap? I've done a search with mixed messages...
I recently did a 2.73 to 3.42 rearend swap on my 00 Z28 (stock tire height and 4L60E) and am getting an SES light, but not an ABS inop like some others do after a gear swap.
A friend of mine has HPTuners and has helped calibrate my speedo, but from what I've been reading I need further recalibration for the shift points
(up and down shifts), shift firmness, and whatever else is causing the SES light after the swap.
Anybody know?
Does anyone know exactly what programming is needed following a gear swap? I've done a search with mixed messages...
I recently did a 2.73 to 3.42 rearend swap on my 00 Z28 (stock tire height and 4L60E) and am getting an SES light, but not an ABS inop like some others do after a gear swap.
A friend of mine has HPTuners and has helped calibrate my speedo, but from what I've been reading I need further recalibration for the shift points
(up and down shifts), shift firmness, and whatever else is causing the SES light after the swap.
Anybody know?
Last edited by Ragtop 99; 11-02-2005 at 08:45 PM. Reason: Double Post, So this thread was closed.