1nastyss

iTrader: (12)

I am about to gte my 9 inch put in my car, i came across a good deal on a Dennys driveshaft out of a 95 Z thats getting parted out, just wondering if it will work with my 01 SS......BTW both cars are 6 speeds, 9 inch with 1350 yokes.

teke184

iTrader: (5)

driveshafts are interchangable from LT1 to LS1...with stock rears.

so assuming both cars have the same 9"...than the shaft should swap

KCFormula

iTrader: (4)

It should be close enough to fit regardless although you may have to manipulate the length a little by adjusting the lower control arms.

1nastyss

iTrader: (12)

Thats cool, thanx for the post's guys

BlackScreaminMachine

iTrader: (17)

It should be, I took my Denny's n20 ready DS that I had for my 94 z28 with a auto and moser 12 bolt and its going into my m6 2002 t/a, I put them next to each other, exact size

EPP

iTrader: (22)

The automatics and the manuals use the same length driveshaft, and the LT1 and LS1 shafts are the same length. Bob

WolfgangX

iTrader: (3)

I think the LT1 driveshafts are 2.5" steel and the LS1 shafts are 3.0" aluminum, if that makes any difference to you.