9" complete third member parts list?
#1
LS1TECH Sponsor
Thread Starter
iTrader: (33)
Join Date: Jul 2002
Location: Out on the farm in Central IL
Posts: 4,399
Likes: 0
Received 0 Likes
on
0 Posts
9" complete third member parts list?
If you were putting together a complete center section for a high HP (1000 for ***** and giggles) application what parts would you use and why. Spool is a given. 3.50 ish gear is also a given.
#2
LS1Tech Sponsor
iTrader: (22)
Join Date: Mar 2005
Location: 32639 Groesbeck HWY. Fraser MI 48026
Posts: 1,593
Likes: 0
Received 0 Likes
on
0 Posts
I was running over 1000 RWHP last season and here is the parts list I ran,
Strange Nodular iron case with billet caps 3.250 bore,
Mitler Brothers aluminum pro pinion support for a 35 spline pinion shaft,
Strange 4.11 Pro gear with a 35 spline pinion,
Strange 35 spline spool with 1/2 20 ring gear bolts,
Strange billet 1350 pinion yoke,
Timken bearings.
Now this year I plan on running over 1400 RWHP thru a MT drag radial so I have upgraded to a Mark Williams aluminum case and pinion support with 40 spline spool for a 3.250 case, same 4.11 pro gear, same yoke, new Moser housing with a back brace and gun drilled and star flanged axles. I should be good for 6's with this assembly just as long as the ring gear bolts are wire tied.
Scott @ DLS
Strange Nodular iron case with billet caps 3.250 bore,
Mitler Brothers aluminum pro pinion support for a 35 spline pinion shaft,
Strange 4.11 Pro gear with a 35 spline pinion,
Strange 35 spline spool with 1/2 20 ring gear bolts,
Strange billet 1350 pinion yoke,
Timken bearings.
Now this year I plan on running over 1400 RWHP thru a MT drag radial so I have upgraded to a Mark Williams aluminum case and pinion support with 40 spline spool for a 3.250 case, same 4.11 pro gear, same yoke, new Moser housing with a back brace and gun drilled and star flanged axles. I should be good for 6's with this assembly just as long as the ring gear bolts are wire tied.
Scott @ DLS