z28_YOU_HO

iTrader: (7)

Alright well i have full bolt ons and a tci3500 converter..im kinda worried about my rear takin a crap on me. Gonna do a MTI X1 cam in a few months and i dont even think i should romp on it from a slow roll 1st gear..What rear should i do thats not going to cost me and arm and a leg? Might throw a 100shot on after the cam btw

02 BLK WS6

iTrader: (11)

If you are that worried about it, get a 9'',12 bolt, or drive that car like a grandma. I have a 10 bolt still and have been deep in the 11's for a whole season before I busted the ring gear. Tear down and rebuilt again with stock gears and no twist of the splines on the axles yet. Average 60' in the 1.63-1.67 with some tire spin.

transam69230

iTrader: (49)

Just don't put any sticky tires on the back and you will be alright.

RIDINFILTHY

iTrader: (10)

ive ran my stocker for over a year now with no problems, avg. 60 is 1.73 and i go to the track atleat twice a month, and i run DR everyday i drive it

Slvr00Bird

iTrader: (2)

Well you guys have freaks then... Hell, I had mine whining like banshee when I had my v6 in it... Rebuilt it when i threw the LS1 in it and threw in some 3.73s and it wasnt long till she was back to normal... I'm expecting her to go out fairly soon... Oh and all ive ever ran are cheap street tires and its never been to the track... So for the 10 bolt enthusiasts

keliente

iTrader: (22)

It's different when you have an auto...

Ryans99ls1

iTrader: (16)

Buy a girdle for now and once she goes have some money saved up for a 9inch

omcar

iTrader: (10)

Been racin the stock rear with 3.73s 4 times a month for years..so far so good.. Change fluid and take care of it.

383jake

iTrader: (2)

i had 3:73's in my ten bolt. but i daily drove the **** outa it... started makin noise and finaly went out. it was in a t56 car too though.

COOKIE MONSTER

iTrader: (5)

x2, but I wouldn't get a 9", I'd get a 12 bolt if you have an automatic.

addicted2fun

I blew my 10 bolt 3x before i bought my 12 bolt. Blew it once on the track with current setup in sig with a set of ******* and slicks launching at 6k (wasnt the first time) with 4.10's. I did that a few times and finally blew it up (that one day). 2nd time was on the track again same setup as last time, launching at 4.5k (first launch of the day) and crunch goes the rear end. Then i had my mechanic look at it he repaired it, had my street tires on and he smashed the gas and broke it right infront of the shop. So, after the 3rd repair he came up to me and said, get a 12 bolt man... you will never see me again... thats what i did, bought the 12 bolt w/ 3.73's for street/strip purposes and havent looked back.