askkmb

iTrader: (3)

Hello, im trying find out basically how far the supercharger pulley sticks out. If you could measure from in front of the head to lets say the belt or from the block to the belt or so. Some pictures with measurements would be nice. I'm trying to put a lsa supercharger on a truck with the stock truck accessories.

askkmb

iTrader: (3)

This is not camaro specific so ill post this in the gen IV external engine section.

Scoggin Dickey

iTrader: (34)

4.5" from the block to the back edge of the supercharger belt

askkmb

iTrader: (3)

Okay thank you very much. That is the supercharger pulley and not the other accesory drive pulley, right?

Scoggin Dickey

iTrader: (34)

Correct. I don't recall the measurement to the back of the main accessory belt. I can check tomorrow if you need to know that. I think it is 3"

askkmb

iTrader: (3)

I dont need to know that. However could you also check the width of the supercharger belt?

Jablowme

iTrader: (44)

the truck is 6 rib the lsa/zl1 is 8 rib the truck lines up with the center of the 8 lsa pulley but your truck damper is smaller dia and wont spin the charger fast enough or grip it hard enough if you put a smaller pulley on it

askkmb

iTrader: (3)

My engine has higher compression so i dont need it to spin that fast but i have a bigger cam so it will even lower the psi some more, maybe it wont work. But im thinking maybe ill just install the lsa belt system.