dickwiley

Ok so when I was at the junk yard gettin my motor the guy was lifting it with a fork lift. When he was sitting it down the fork broke one if the studs on top of the intake also puttin a hole in it. I want to figure out how to fix it. My plans are to take all the crap off it and smooth it out. I saw one on another forum that looked very nice. Just gotta figure out how to fix the hole. Plastic epoxy, fiberglass? Any ideas. I have another manifold thats good I just want to try and fix this one so I can try and smooth it out nice and clean.

Marc 85Z28

iTrader: (8)

Get another from the junkyard. Should cost about as much as that tube of epoxy you want to use on the broken one.

1_MEANZ28

iTrader: (4)

X2 ..in my opinion broken plastic intakes are never the same