Adding 85mm TSP lid what do I do with the air hose that goes into my SLP lid? I am adding a TSP 85mm air lid to my 2002 SS. I need to know what to do with the air hose that is currently connected to a fitting in my SLP lid? I have seen a few people that had an air filter attached to the hose. where can I get the filter at local in Houston Tx? Is there a way to do away with this all together? If so how? |
Well I would remove the whole AIR system if you dont have to worry about emissions. If you would like to keep the system go to autozone or something and look for a little cone filter. I dont know the size just guessed and it fit pretty good. Then stuff it down by the fuse box. I did this for a while till my header install when I removed the whole system. |
I already have longtube pacesetter headers so what is involved with removing it completely? I will be having heads and cam along with a fast 92/92 installed at the end of the week so the car will be tuned then also. |
You can just unplug the wires on the air pump for now and have it tuned out when you get your tune. To remove it completely: you need to get air block off plates for your headers, disconnect and block of the header connections, then follow the tubes from the headers and disconnect/remove everything all the way back to the lid. The solenoid on the rear drivers side of the intake is the hardest part. |
i would just drill a hole and install it back into the new air lid if it was me.. |
^^i would not do that but thats just me just get a little cone filter or remove your air system |
Originally Posted by LS1-NAVY
(Post 10855905)
^^i would not do that but thats just me just get a little cone filter or remove your air system |
I put a little cone filter on it. The car is going in tomarrow for heads, cam , and intake along with a tune so Iwill talk to them about deleteing the air on the car and tunning it out. |
Originally Posted by chrs1313
(Post 10856858)
agreed...i wouldnt do that either...shit i didnt even drill a hole for my IAT sensor...i am running the one in the 85mm MAF :D |
Originally Posted by bigfatls6
(Post 10858717)
The 85mm lid I got was used and some one else already drilled the hole in it other wise I would have just used teh one on the mass air. What kind of 85mm lid are you using? |
1 Attachment(s) The attachment shows a cone filter on mine and then I removed the system. I will post a link to a thread that has some good info in about the parts for the solenoid. https://ls1tech.com/forums/generatio...questions.html |
Thanks thats a pretty informative thread about the air system. I put a cone filter on it for now and when the finish installing my heads and cam and fast 92/92 they are going to remove the air all together. |
All times are GMT -5. The time now is 06:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands