69blackwhss

iTrader: (9)

hey i have the nw 92mm tb an using the stock maf. what can i use to bolt this up an were do i get it i dont think i can use a stock air duck an i dont have it lol i got this motor from ebay an it didnt come with all the parts an am installin it into a 69 camaro.

69blackwhss

iTrader: (9)

someone got to know how?

69blackwhss

iTrader: (9)

?.....

peterlawl84

iTrader: (12)

Ive heard a couple say they used the stock bellow or SLP's smooth bellow by dipping it in hot warm/warming up in microwave to soften it, then stretch it over the tb openning. I am about to do the same install, would like to get confirmation on this as well.

69blackwhss

iTrader: (9)

that could work but thats alot of mm diff between the stock maf an to the 92mm.

peterlawl84

iTrader: (12)

Yea thats what I thought, I will find out, my nw tb is on the way.

tspence45

iTrader: (30)

I bought a smooth bellow of eBay and it worked. It was actually slightly too large on my stock TB, and works on my NW 92. It's still a real pain to get it over the TB openning though. http://cgi.ebay.com/ebaymotors/LS1-c...item3ca72bc33a

69blackwhss

iTrader: (9)

hey man do u have that bolted up to a stock maf? an if so how long is it for end to end? an could u get a pic of me.. thanks alot jason

69blackwhss

iTrader: (9)

? need some info

Intercooler2

iTrader: (24)

I have the stocker on my 96mm. I just trimmed some of the tight plastic at each in and put it on. Didn't even heat it in water.

69blackwhss

iTrader: (9)

u got any pics of it installed brother

Intercooler2

iTrader: (24)

I do at home. What in particular are you looking for?

69blackwhss

iTrader: (9)

like where u had to cut it to make it fit. i would like to know be4 i buy one from another member off here. are if i need to get after maket which would suck. cuz it would cost more money.

tspence45

iTrader: (30)

Yeah, I'm using the stock MAF. Did put ported ends on it yesterday though. I'll measure it in a little bit and try and get some pics for ya.

Intercooler2

iTrader: (24)

When you have the bellow off it is real easy to see. It is like a 1/8" lip that is rolled at the ends. Trim it past that to the flat part and it opens things up.

69blackwhss

iTrader: (9)

thanks for all the help guys i got one from lowers like someone eles did. it cost me the same for a stock bellow anyways an this one is smoth so i should be a little more hp lol.