LS1TECH - Camaro and Firebird Forum Discussion

LS1TECH - Camaro and Firebird Forum Discussion (https://ls1tech.com/forums/)
-   Generation III External Engine (https://ls1tech.com/forums/generation-iii-external-engine-6/)
-   -   Muffler Q's (https://ls1tech.com/forums/generation-iii-external-engine/1306731-muffler-qs.html)

Maroslut2001 Jul 16, 2010 09:41 PM

Muffler Q's
 
Hey i am looking at running just my y-pipe with a muffler and turn down on the end of it... I was just wondering if anyone has any sound clip of different mufflers set up like this??? I know it will be loud which i dont mind i just want it to sound good at the sametime... I do have lt's,ory,torquer v.2 and heads so it should sound mean with whatever i get... all suggestions are welcome!!!

Blackhawk777 Jul 16, 2010 10:08 PM

If you get a magnaflow 4x9 muffler, it's actually pretty reasonable for volume levels and drone. Hell pretty much any magnaflow muffler is good. Just on the quiet side if you don't have headers.

Maroslut2001 Jul 16, 2010 10:22 PM

Thanks for the response!!! i was looking at those but was kinda worried about ground clearance, i am lowered and the roads here in Colorado suck lol... would bullets be too loud for this type of setup??? i was maybe looking into the moroso spirals or maybe something like a borla xr1... Or maybe a true dual setup i just need something that is easy to swap out for my stock stuff every 2 years cause of emissions bullshit.

Blackhawk777 Jul 16, 2010 10:29 PM

The spiral flows would be stupid loud. Magnaflow does make a bullet. 4 inch thick case. Otherwise I'd recommend the borla xr-1. It all depends on what is too loud for you (or in some cases, your neighbors haha). But either should have a good sound

Maroslut2001 Jul 16, 2010 10:41 PM

I have been driving around for awhile with the lt's and ory with a stock catback with the muffler swapped out for a straight pipe... i do like loud but also want a good sound to it, sounds like the 4x9 will be the way for me to go.

Blackhawk777 Jul 16, 2010 10:42 PM

Alright, Post up a vid once it's done!

Maroslut2001 Jul 16, 2010 10:48 PM

Sad to say it wont be for alittle bit, its been a project for awhile now and just my luck i am almost done with it and got a hernia.

Blackhawk777 Jul 16, 2010 10:52 PM

OOO brutal. Should sound good though. Magnaflow always does with headers.

Maroslut2001 Jul 16, 2010 10:55 PM

Ya shitty haha... Thanks for the advice!!!

Blackhawk777 Jul 16, 2010 10:57 PM

No prob:chug:


All times are GMT -5. The time now is 12:29 AM.


© 2026 MH Sub I, LLC dba Internet Brands