Ron_Stoppable

iTrader: (1)

Is there a cheaper alternative than paying $6.00 a piece for the seals that go under the coolant crossover and rear coolant block off plates. Thats really ridiculous that GM would charge that much for something you can barely see with the naked eye. Does dorman have a cross reference or anything? I have the later style not the gasket type

sjsingle1

iTrader: (1)

dorman does sell those gaskets.......or you can get the LS6 style crossovers which have a built in O ring

Ron_Stoppable

iTrader: (1)

Yeah i have the LS6 style crossover. Witht the two block offs on the back. They are the oring type. Can you use dorman gaskets on these or no?

mike171562

iTrader: (4)

I have the LS1 style and used these off the shelf at Oreillys

Ron_Stoppable

iTrader: (1)

Ok cool thanks man

01ssreda4

iTrader: (96)

Yep, and available at most auto parts stores.

thunderstruck507

iTrader: (18)

Didn't know that...I spent the $6 each for them during my head/cam swap and was pretty pissed about it.

dr_whigham

iTrader: (49)

****!! Me too!

sjsingle1

iTrader: (1)

the LS6 style does NOT use gaskets

chevybayboy

iTrader: (6)

Yea I also payed 6 each

Stu_x24x

iTrader: (17)

+1. Back when I ordered my parts the guy I spoke to said gaskets aren't needed for the LS6 crossover and block-offs. I didn't put any on and have had no issues for the past few years.

01ssreda4

iTrader: (96)

Mine had em....

sjsingle1

iTrader: (1)

i think the OLD style LS6 had gaskets........newer has O rings