NC_John

iTrader: (1)

Will the factory knock sensors and wiring harness fit under the LSXRT intake? (2004 LQ4 if it matters)

I did a search but couldn't find anything about it (and killed 45 minutes getting distracted with other stuff that came up doing so)

Thanks

slogo

Yes, the sensors are below the surface of the valley cover, and the wires do not take
much room. This cover is not bolted down but you can see enough space for wires.

NC_John

iTrader: (1)

I knew the arrangement but looking at the intake wasn't sure there was enough room for the seals or the wires. Thanks! (That intake is a beast, isn't it?)

64post

iTrader: (5)

Good to know but does the LS6 pcv valley cover work with the LSXRT? Steam tube set up?

1970camaroRS

iTrader: (8)

No, LS6 PCV doesn't work. I have my rear steam ports blocked and run only the front just like the stock LQ4 setup.

And for OP, the knock sensors fit and work just fine. Been running mine for more than two years now.

NC_John

iTrader: (1)

Thank you sir!