Ultra Z with FTRA/SSRA
#1
TECH Resident
Thread Starter
iTrader: (23)
Join Date: Jun 2002
Location: Tri-Cities, WA
Posts: 913
Likes: 0
Received 0 Likes
on
0 Posts
Ultra Z with FTRA/SSRA
Is there any use for this once the hood is sealed up properly to the air box? I am putting the WS6 lower with my TSP 85mm lid and switching the Fernco out for SLP smooth bellows since I believe the angle will be too great. It's a little piece of mind and it saves me from cracking the lid. Now would there be any use to doing this work and STILL putting in one of the two ram air kits? Would it null each other out or make it too turbulent in there? Are there any Ultra Z seal kits out there (or even WS6) that I can buy or is it a trip to the parts store? Please let me know your thoughts, thanks.
#2
TECH Fanatic
iTrader: (5)
Join Date: Jan 2005
Location: Southwest Ranches, Florida
Posts: 1,112
Likes: 0
Received 0 Likes
on
0 Posts
I was running a similar set up with my WS6, I had the BGRA and SLP CAI. I felt a litter difference after I installed the BGRA when the SLP CAI was on.
Try it, if anything make some runs with both on and only 1 on and check for urself
Try it, if anything make some runs with both on and only 1 on and check for urself