CKP, Low Oil Level, Starter Wiring with Headers. Solutions for routing?? Has anyone came up with a good method to protect and route the crank sensor, low oil level, and starter wires around a 1 7/8 Kooks hedder. It seems that if these were longer they could be routed more nicely to aviod the hedder heat, if it is even a problem. Just put mine together and don' t like how close this harness is to the hedder tubes. Looked on Casper's site and didn't see any extensions for this harness. Anyone come up with a good solution or am I worrying abuot something that is not going to be problem. It is heat taped from the factory.....but damn its close! |
I wrapped a bunch of wires with thermal reflective wire harness wrap. Luckily, a friend had some I could borrow so I could finish it up. I ordered wrap to replace what I used from Thunder Racing. They had the best price I could find. 138-010413 DEI Cool Tape, 2"x60' $52.99 138-010416 DEI Cool Tape, 1-3/8"x30' $26.99 |
I wrapped mine with aluminum foil and duct taped them as far away as possible. |
All times are GMT -5. The time now is 05:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands