Question for Hooker catback owners.....
Thread Starter
Teching In
Joined: Feb 2007
Posts: 47
Likes: 0
From: Alabama
Question for Hooker catback owners..... I installed my Hooker a few weeks back and have a question for you guys. My muffler/tailpipe hangs lower on the driverside, this makes my tailpipes come out of the muffler at different angles and they look crooked once you get the tips on there. Anyone else have similar issues.
pat
pat
OK, here is what I did, take the tail pipe on the drivers side and connect it as high as you can on the hanger, the hole above the one your using, i did that and now my muffler and tails are level. You should have that tailpipe loose where it connects to the muffler, after you rasie your tail to the higher hanger hole, push up your muffler and tail up until your muffler and tails are level and then tighten the tail on the muffler
Last edited by RacerScott; Sep 21, 2007 at 07:50 AM.
I just went out and looked at my car and the higher hanger hole I was refering to is more like a slot, and it doesnt make the tails perfect, but makes them a lot better. I sure a different hanger that doesnt hang as low would sove the problem.
my driver side tail pipe shook pretty bad @ idle, so i had to fix that. my muffler also hung lower on that side like you were saying. i went to a exhaust shop and had them weld in a totally different hanger for that side. now its solid, and doesn't move at all.
pretty nasty weld job, but it works
back is pretty straight now
pretty nasty weld job, but it works
back is pretty straight now
Last edited by ProjecT 9; Sep 22, 2007 at 10:29 AM.
