Help, Fuel in Oil!
#1
Help, Fuel in Oil!
When I changed the oil in my car it smelled like gas. The oil had about 4k and approximatly 3k of that was with an ls6 intake and qtp headers installed and no tune. I didn't notice anything weird about the oil when I drained it or looked at it on the dipstick other than it smelled like gas. The oil pressure was also normal. I've done quite a bit of reading on here and it sounds like it could be a couple of thihngs 1. factory tune is dumping to much fuel in and its making its way to the oil pan, 2. I have a leaking injector and the fuel is leaking into the oil after I turn off the motor.
My understanding was that it's not a problem to run headers and an intake without a tune, simple because your not changing enough to throw off the tune that far. I just raced the car at the track and nobody noticed any kind of smoke coming out of the exhaust pipes so it doesn't look like its running that rich at wide open throttle but there are signs of it running rich as the paint has turned brown around the exhaust on the bumper. The motor seems to run strong and I trapped 107 which is 3 mph faster than before the mods.
As far as checking for a leaking injector I know I need to do a leak down check of the fuel rail but how can I tell an injector leak apart from the fuel psi just going down at a normal rate? I would assume that some of the pressure would eventually be releivied back to the fuel tank normally otherwise the fuel pump wouldn't be programmed to prime the system before start up. The only other option I can think of is to pull off the fuel rail and prime the system and see if any of the injectors leak (can this be done without removing the intake?).
What do you guys think is the cause of the fuel getting into the oil?
Thanks in advance for your help!
Brad
My understanding was that it's not a problem to run headers and an intake without a tune, simple because your not changing enough to throw off the tune that far. I just raced the car at the track and nobody noticed any kind of smoke coming out of the exhaust pipes so it doesn't look like its running that rich at wide open throttle but there are signs of it running rich as the paint has turned brown around the exhaust on the bumper. The motor seems to run strong and I trapped 107 which is 3 mph faster than before the mods.
As far as checking for a leaking injector I know I need to do a leak down check of the fuel rail but how can I tell an injector leak apart from the fuel psi just going down at a normal rate? I would assume that some of the pressure would eventually be releivied back to the fuel tank normally otherwise the fuel pump wouldn't be programmed to prime the system before start up. The only other option I can think of is to pull off the fuel rail and prime the system and see if any of the injectors leak (can this be done without removing the intake?).
What do you guys think is the cause of the fuel getting into the oil?
Thanks in advance for your help!
Brad
#4
ЯєŧąяĐ Єl¡m¡иąŧøя ™
iTrader: (18)
You may be looking too deep into this.
Most of the time when I have changed the oil in ANY car it had a small scent of fuel.
Sidenote: I would go get it tuned and find out what your A/F is to find out if you are super soaking your bottom end with the injectors. And if they are stock find out what the duty cycle is showing. Changing the intake and putting headers on will really whack a stock tune in most cases.
Most of the time when I have changed the oil in ANY car it had a small scent of fuel.
Sidenote: I would go get it tuned and find out what your A/F is to find out if you are super soaking your bottom end with the injectors. And if they are stock find out what the duty cycle is showing. Changing the intake and putting headers on will really whack a stock tune in most cases.
#5
You may be looking too deep into this.
Most of the time when I have changed the oil in ANY car it had a small scent of fuel.
Sidenote: I would go get it tuned and find out what your A/F is to find out if you are super soaking your bottom end with the injectors. And if they are stock find out what the duty cycle is showing. Changing the intake and putting headers on will really whack a stock tune in most cases.
Most of the time when I have changed the oil in ANY car it had a small scent of fuel.
Sidenote: I would go get it tuned and find out what your A/F is to find out if you are super soaking your bottom end with the injectors. And if they are stock find out what the duty cycle is showing. Changing the intake and putting headers on will really whack a stock tune in most cases.
I'm plannig on getting a wideband and a tune in the very near future.
#6
TECH Fanatic
Join Date: Feb 2004
Location: Lexington, KY
Posts: 1,259
Likes: 0
Received 0 Likes
on
0 Posts
The headers and intake will throw off the factory tune. But if everything is correct with the install, most of the time they will run lean. Is it throwing any codes? If it has an air leak upstream of the 02's, it could make them think the car is running lean and over compensate by dumping fuel in it.
Trending Topics
#10
The headers and intake will throw off the factory tune. But if everything is correct with the install, most of the time they will run lean. Is it throwing any codes? If it has an air leak upstream of the 02's, it could make them think the car is running lean and over compensate by dumping fuel in it.
I do have a check engine light but that's from deleting the egr, air and cats.... I haven't had the codes checked though so it could be something else, I'll try and take it by a parts strore and get it scanned just to be sure.
Thanks everyone for the help!
#11
Its not always this but loose piston fit or poorly sealing rings can give you fuel smell without other problems like injectors leaking etc. My TA ALWAYS had a terrible gas smell at 3k oil changes for over 100k miles. It had a few loose pistons and used about 1 qt of oil evey 2k.
Another sure sign of loose piston fit-poor ring seal is DARK oil. It gets dark quick from all the combustion gases and carbon getting past the rings and pistons.
My Ta oil gets dark FAST while my newer Formula stays clean looking even after 4 k miles.
Another sign to look for is hard starting hot...if you have a injector leaking its going to start like ***. So if it starting ok and running ok its time to consider piston wear or fit and piston ring seal.
Another sure sign of loose piston fit-poor ring seal is DARK oil. It gets dark quick from all the combustion gases and carbon getting past the rings and pistons.
My Ta oil gets dark FAST while my newer Formula stays clean looking even after 4 k miles.
Another sign to look for is hard starting hot...if you have a injector leaking its going to start like ***. So if it starting ok and running ok its time to consider piston wear or fit and piston ring seal.
Last edited by HotSilverBird; 05-31-2010 at 02:56 PM.
#12
TECH Senior Member
iTrader: (71)
I would try to not over examine too much man.. Do the simplest thing and get the codes ran. After that (which is likely the problem) get a tune, base or dyno whichever you think is best for your situation.
If that doesn't solve your problem, then go to the more advanced and rare things that could cause this problem.
If that doesn't solve your problem, then go to the more advanced and rare things that could cause this problem.
#15
Its not always this but loose piston fit or poorly sealing rings can give you fuel smell without other problems like injectors leaking etc. My TA ALWAYS had a terrible gas smell at 3k oil changes for over 100k miles. It had a few loose pistons and used about 1 qt of oil evey 2k.
Another sure sign of loose piston fit-poor ring seal is DARK oil. It gets dark quick from all the combustion gases and carbon getting past the rings and pistons.
My Ta oil gets dark FAST while my newer Formula stays clean looking even after 4 k miles.
Another sign to look for is hard starting hot...if you have a injector leaking its going to start like ***. So if it starting ok and running ok its time to consider piston wear or fit and piston ring seal.
Another sure sign of loose piston fit-poor ring seal is DARK oil. It gets dark quick from all the combustion gases and carbon getting past the rings and pistons.
My Ta oil gets dark FAST while my newer Formula stays clean looking even after 4 k miles.
Another sign to look for is hard starting hot...if you have a injector leaking its going to start like ***. So if it starting ok and running ok its time to consider piston wear or fit and piston ring seal.
I would try to not over examine too much man.. Do the simplest thing and get the codes ran. After that (which is likely the problem) get a tune, base or dyno whichever you think is best for your situation.
If that doesn't solve your problem, then go to the more advanced and rare things that could cause this problem.
If that doesn't solve your problem, then go to the more advanced and rare things that could cause this problem.
Thanks for everyone's help!
Brad