rio95cobra

iTrader: (3)

I'm picking my '00 SS m6 up from vengeance this week, and am totally fired up! Me and a friend started to do a cam swap a couple weekends back but it came to a halt when we removed the cam and a few of the lobes were chewed up from lifter failure! The engine had been making some noise, so I was half way expecting it. So we towed the car up to vengeance racing in cumming, ga and they're pulling the heads and replacing it with comp lifters and installing my new MS3 cam w/ a 112lsa, prc dual springs and pushrods, melling oil pump, ls2 chain, adding an slp underdrive pulley, and dyno tuning it. What kind of power would you guesstimate it makes??

The mods on it already are an slp lid, ls6 intake, and long tubes w/ tsp true duals. I still have the stock 3.42's and its a 6 speed. Ill post up a dyno sheet when I pick it up, Wednesday is when they're thinking it'll be done

BrntWS6

iTrader: (7)

Should be around 400rwhp with that cam.

trance565

iTrader: (4)

Id guess 400-410.

BobDoLe

iTrader: (11)

with the labor to pull the heads, why not throw a different set of heads on there? i'm sure you could find a set of 243's lying around their shop floor somewhere.

2slow2flurry-ous

iTrader: (13)

Its not exactly like that. Customers usually keep old parts to resell. Good luck w the car. No suprise here should b close to 400 hp

rio95cobra

iTrader: (3)

I'm sure they do have a spare used set on their shelves somewhere, and if I had the extra $ I would totally do it.. its just costing me out the *** as it is, and I can't scrounge up enough to buy some. Its whatever.

rio95cobra

iTrader: (3)

Hang tight.. hopefully ill get it back tomorrow. Ill post up a dyno sheet when I do