LS1TECH - Camaro and Firebird Forum Discussion - Drivers side ground wasn't connected?

LS1TECH - Camaro and Firebird Forum Discussion (https://ls1tech.com/forums/)

- Generation III Internal Engine (https://ls1tech.com/forums/generation-iii-internal-engine-5/)

- - Drivers side ground wasn't connected? (https://ls1tech.com/forums/generation-iii-internal-engine/1446881-drivers-side-ground-wasnt-connected.html)

salspmp

Jul 20, 2011 02:44 PM

Drivers side ground wasn't connected?

I was replacing my 4l60e with an aftermarket 4l60e. When putting in the new trans I found that the ground on the drivers side of the block was not connected. I have no idea how long this hasn't been connected. I can only assume it happened during or after I replaced the heads.

What issues could this have caused?

salspmp

Jul 20, 2011 03:34 PM

Come on people.... if you went and disconneted that ground wire on your car... what issues would you have?

Redbull87

Jul 20, 2011 03:41 PM

probably nothing since the harness shares the grounds when it reaches near the ecm.If something didnt have a ground on a sensor then the ecm would have given you a code by now due to a fault in the circuit.I wouldnt worry about one missed grounding point.

All times are GMT -5. The time now is 11:32 AM.