Help with .030" valve shims OD and ID I need
#1
On The Tree
Thread Starter
Help with .030" valve shims OD and ID I need
I need help on what OD and ID valve shims i need the thickness I need is .030" and im going to be using it with ls6 valve springs and then later on going to use pac 1218 with a Howard's ASA camshaft
#2
TECH Senior Member
Have you called ANY of the cam companies about this? They will give you a quicker answer than the internet, and be correct.
#4
TECH Senior Member
iTrader: (4)
I bought them from JEGS and bought:
"SPRING SHIM .015 X 1.250 Part # 249-4736-16"
You will need to look for the thicker part but hopefully this helps. If you are using the one piece seal/seat than you need to put the shims on top of the seal/seat so verify the ID will fit over. If you are using umbrella seals they go on before the valve seal.
"SPRING SHIM .015 X 1.250 Part # 249-4736-16"
You will need to look for the thicker part but hopefully this helps. If you are using the one piece seal/seat than you need to put the shims on top of the seal/seat so verify the ID will fit over. If you are using umbrella seals they go on before the valve seal.