Z28/LS6 build thread...with help from WS6 Store
#23
I know I know....been slow going lol. Super tough to get time lately. After a dozen cans of brake cleaner the motor is completely torn down and cleaned. New cam bearings installed.
crank is installed with the bearings. Thrust endplay looked good at 4 thou, and main clearance was between 1.75 and 2 thou. Crank reluctor run-out was within spec, always nice. Next step is gapping the rings.
crank is installed with the bearings. Thrust endplay looked good at 4 thou, and main clearance was between 1.75 and 2 thou. Crank reluctor run-out was within spec, always nice. Next step is gapping the rings.
#24
Hoping memorial day weekend I make some serious progress.....In the meantime, I would just like to state that taking apart stock motor mounts and melting out the old ones is a royal PITA. That is all. We'll that, and I just ordered a rear girdle cover, tubular LCA's, and a driveshaft safety loop.
#31
Short block is together. Going to get the right 1 piece valve seals from WS6 Store for dual springs and then assemble the heads after cleaning. Once the heads are on we have a tool that will let us prime the oiling system so I can make sure we see pressure before putting it in the car.
#38
At one point I was going to send them out...but everything snowballed and I decided stock 243s are pretty good and i would put the money elsewhere in the build between prothane motor mounts, new clutch line, new slave, LCAs, girdle, Straub trunion upgrade, driveshaft loop, etc. Knowing me, we gapped the rings a little bigger for boost because boost rules and at that point I won't care about ported 243s lol.
#39
TECH Veteran
iTrader: (40)
At one point I was going to send them out...but everything snowballed and I decided stock 243s are pretty good and i would put the money elsewhere in the build between prothane motor mounts, new clutch line, new slave, LCAs, girdle, Straub trunion upgrade, driveshaft loop, etc. Knowing me, we gapped the rings a little bigger for boost because boost rules and at that point I won't care about ported 243s lol.