Need 120mm drive by wire throttle body
06-12-2019, 03:37 PM
#22
Well if that flows enough for 7500 rpm on a beast 468 then it should flow enough for 8500 on a 427 with most likely less flow anyway! thanks for the heads up fnbadaz06.
Now I gots to figure out a way to bolt this bitch up! cause it wont fit!
Now I gots to figure out a way to bolt this bitch up! cause it wont fit!
06-12-2019, 06:34 PM
#23
Moderator
iTrader: (4)
Join Date: Jul 2014
Location: My own internal universe
Posts: 10,446
Received 1,835 Likes
on
1,145 Posts
Originally Posted by twistedneck
Well if that flows enough for 7500 rpm on a beast 468 then it should flow enough for 8500 on a 427 with most likely less flow anyway! thanks for the heads up fnbadaz06.
Now I gots to figure out a way to bolt this bitch up! cause it wont fit!
Now I gots to figure out a way to bolt this bitch up! cause it wont fit!
06-13-2019, 04:41 PM
#24
of course. but what about the giant mismatch in port location? that’s why i’m thinking adapters. current intake is s special one off and it still has 1/2” thick adapters.