I've got a few Miles on my current motor....
#1
Launching!
Thread Starter
Join Date: Nov 2001
Location: Toronto, Ontario
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
I've got a few Miles on my current motor....
and I'm looking to do a new motor. I'd like to do an LS2 Block but how big of a stroke are people using? Is a 4.125 going to be too big?
I had a 01 Hawk with H/C that made 400rwhp/380rwtq but that car was stolen and I found another car and want to build the whole motor this time as 400rwhp just wasn't enough.
Thanks.
I had a 01 Hawk with H/C that made 400rwhp/380rwtq but that car was stolen and I found another car and want to build the whole motor this time as 400rwhp just wasn't enough.
Thanks.
#2
8 Second Club
Join Date: May 2002
Location: Toronto
Posts: 1,043
Likes: 0
Received 0 Likes
on
0 Posts
HI Jim (it's your buddy Andre here)
LS2 block is very simmilar to the 6.0 Iron block... you could build a 402 no problem... To go much bigger you will need to resleave, and I don't think this is what you have in mind!
402 would be based on 4.000 stroke and stock bore...
I am doing some research on this scenario as well... I might not end up 'pumping iron' next summer!
LS2 block is very simmilar to the 6.0 Iron block... you could build a 402 no problem... To go much bigger you will need to resleave, and I don't think this is what you have in mind!
402 would be based on 4.000 stroke and stock bore...
I am doing some research on this scenario as well... I might not end up 'pumping iron' next summer!